Current Sensor S1
Recording of welding currents (mounting at ground wire) for controlling dedusting plants in combination with ZIEHL-controls type STW. Recording the state of a consumer of electricity (on or off or defective).
In general the current-sensor S1 is used where the current-flow is to be detected, with the exact value of the current either known from the power consumption of the connected consumer or does not matter for the evaluation.
For evaluation of measuring data in more than 1 cable, these outputs of several current-sensors can be connected in parallel (OR-evaluation).
- switching point app. 5 A (option: adjustable 5-30 A)
- monitoring of AC and DC currents
- LED for current flow
- mounting without disconnection of cable possible
- 2 transistor-outputs, switching + and -, direct connection to a PLC possible
- connection to current-relays ZIEHL type STW
- robust, sealed execution
- overload capacity: unlimited
Discover the difference between our S1 and our new S1 with switch on/switch off delay!
| Type | S1 (S225694) | S1 - New design (S225697) |
|---|---|---|
| Current | 5 - 30A AC/DC | 5 - 30A AC/DC |
| Switch on/Switch off delay | - | 0 - 10 min |
| Output | 1x PNP, 1x NPN | 1x PNP or NPN, 1x +24V |
| Output load capacity | 20 mA | 20 mA |
| Display | LED yellow: Switching state output | LED yellow: Switching state output |
| LEDs green: - | LEDs green: Output type | |
| Setting | Potentiometer | Button + Potentiometer |
| Connection type | Connecting cable | M12-connector |
| Supply voltage | DC 24 V | DC 24 V |
